Customer Care Phone Number

When setting up or troubleshooting your flight simulation gear, hardware feedback is crucial for quick diagnostics. For flight sim pilots, experiencing a dark device or unexpected behavior mid-setup can be a major pain point, as standard hardware rarely explains what is wrong internally. Instead of forcing you to guess whether your device is malfunctioning, experiencing a software glitch, or simply lacking data communication, the T2 THROTTLE BASE II features a built-in smart LED Status Display.By understanding the specific flashing patterns of this green LED, you can immediately identify the device’s exact state and resolve connection anomalies without frustration. Here is a comprehensive guide to reading and understanding your unit’s LED status codes.

---

The Three Core LED Status Modes

The T2 THROTTLE BASE II communicates its operational and diagnostic health through a single green LED utilizing three distinct flashing behaviors:

1. BOOT Mode (Steady Slow Flashing)

• The Pattern: The green LED flashes continuously and steadily at a slow, 1-second interval.
• What it means: The device is currently initialized in BOOT mode. This indicates that the hardware is ready for a firmware installation, update, or is waiting for its core initialization sequence to be completed by the system software.

2. Operational Mode (Flashing then Steady ON)

• The Pattern: The green LED flashes slowly at a 1-second interval exactly 5 times, and then shifts to a Steady ON state.
• What it means: This is the ideal behavior. It confirms that the throttle base is fully operational. The initial 5 flashes indicate hardware initialization, and the solid green light signifies that both power and dual-way data communication are successfully established between your PC and the simulator controls.

3. Power Supply Only Mode (Flashing then OFF)

• The Pattern: The green LED flashes slowly at a 1-second interval exactly 5 times, and then turns completely OFF.
• What it means: This indicates the unit is in Power supply only mode. The base is successfully drawing electrical power through the USB port (hence the initial flashes), but the PC is not recognizing or processing the data connection.

---

Troubleshooting “Power Supply Only” Mode

If your device exhibits the third pattern (turning completely OFF after 5 flashes), your physical connection needs adjustment. Use the following steps to re-establish proper data flow:

1. Check the USB Cable Connection: Ensure that the provided USB cable is firmly pushed into the port of the base.
2. Verify the Cable Clamp: A loose wire can drop data signals while keeping power pins connected. Make sure the specialized cable clamp is tightly fixed onto the chassis using the Allen wrench (T1) to isolate the plug from vibration or movement.
3. Switch PC Ports: Avoid unpowered USB hubs. Plug the USB cable directly into a motherboard-level USB port on your PC to guarantee full data bandwidth.

---

Conclusion

The smart LED display on the T2 THROTTLE BASE II removes the guesswork from hardware troubleshooting. By taking just a few seconds to watch the green light when plugging in the device, you can instantly verify if you are safely ready to fly, stuck in a boot sequence, or experiencing a data drop—allowing you to fix the issue quickly and keep your focus on the virtual skies.